钢框架中组合楼盖的面内变形

为了研究影响钢-混凝土组合框架中组合楼盖隔板性能的因素,以楼板厚度、框架侧移刚度以及结构平面刚度布置为参数对钢框架中的组合楼盖进行了弹性有限元分析．分析结果表明,除长宽比外,组合楼盖的隔板性能还与其面内刚度以及支撑体系的特性有关．根据分析结果提出了组合楼盖隔板性能的评价方法, 并与试验结果进行了验证．该方法可以为工程实践中评价组合楼盖的隔板性能作参考．     

45钢柱壳膨胀断裂的应变率效应

采用前照明高速分幅照相技术拍摄到在爆轰加载下45钢柱壳表面裂纹生成、扩展及产物泄漏过程的清晰图像,较准确地测量了膨胀断裂的时间与应变。 45钢柱壳在炸药爆轰加载下,断裂应变随应变率的增加而增加,当应变率达到一定值,断裂应变随应变率的增加而降低,出现了动态断裂中的塑性峰现象。     

预应力钢桁架结构分析中的摩擦滑移索单元

为精确模拟预应力钢桁架中连续长索在支撑点的滑动,本文创建了一种考虑摩擦力影响的新单元。被称为摩擦滑移索单元的新单元有三个节点,中间节点为支撑点。本文首先利用弹性悬链线的解析解,建立了弹性悬链线单元,并推导了单元两端点的张拉刚度。摩擦滑移索单元由两个弹性悬链线单元组合而成,根据支撑点处索的滑动方向、索力差、滑动摩擦力和滑移刚度调整两索段的原长,使支撑点两侧的索力满足给定的摩擦关系。算例验证了新单元算法的正确性和高效性,对设计的预应力钢桁架的分析,显示了张拉过程中及使用荷载作用下新单元在结构分析中的应用。新单元可直接用于常规的有限元分析,研究在工作状态或施工中存在连续长索滑移的索结构。     

半刚性钢框架的内力分析

采用二阶非线性分析方法分析和设计半刚性钢框架，包括连接的柔性以及构件的几何非线性的影响，提出了半刚性钢框架中梁柱单元刚度矩阵和半刚性梁的单元刚度矩阵；推导了半刚性梁在集中荷载，均布荷载，线性荷载作用下的固端弯矩的求解公式；连接的柔性对无支撑框架的侧移有很大的影响，设计时通过变化连接的刚度以平衡梁的跨中和端弯矩。     

回火温度对40Cr钢疲劳裂纹萌生寿命的影响

用系统分析的方法，通过三点弯曲疲劳试验，以数值描述的方式，在线跟踪了40Cr钢及其在三种回火温度下疲劳裂纹萌生过程的疲劳损伤，实验结果表明：随着回火处理温度的提高，40Cr钢的疲劳裂纹萌生寿命都有不同程度的提高．但裂纹萌生寿命在低于450℃的温度范围里，随着回火温度的提高，裂纹萌生寿命有明显的提高，在450℃至580℃范围内，随回火温度的上升，裂纹萌生寿命则没有明显的增加．     

Deformation and failure mechanism in AISI 4340 steel under ballistic impact

Deformation and failure mechanism in quench-hardened AISI 4340 steel under ballistic impact is investigated. The influence of microstructure on damage evolution is also evaluated. Strain localization and shear failure along adiabatic shear bands are the dominant deformation and failure mechanisms. The time and critical strain for the commencement of strain localization is influenced by strain rate and microstructure. The microstructure of the steel sample also influenced the type of adiabatic shear bands formed during impact. Failure mechanism involves nucleation of micro-voids, which clusters to form bigger pores. Extremely fine micro-cracks are initiated adjacent to the pores and in shear flow direction along the shear bands. These micro-cracks become interconnected and grow to macro-cracks, which cause fracture of some of the investigated cylindrical steel samples under impact. The susceptibility of the adiabatic shear bands to cracking increases with decreasing tempering temperature of the steel.     

Fatigue criteria for integrity assessment of long-span steel bridge with health monitoring

A structural health assessment (SHA) methodology is developed using data acquired from structural health monitoring (SHM) system installed on long-span bridges. A set of fatigue criteria has been proposed for pre-determining the global state of the bridge structure failure due to fatigue. This involves finding the threshold of fatigue initiation, below which the rate of fatigue damage may be undetectable under current technology or it is economically unfeasible. The state-of-art for large structures corresponds to the initiation of macro-cracks caused by the accumulation of damage generated by actual service loads for the case of bridges. In what follows, consideration is given to developing fatigue crack growth criterion based on the concept of the continuum damage mechanics (CDM). Fatigue accumulative is included in the model where a fatigue limit for multi-axial stress state is considered. The proposed criterion advocates the evolution of micro-crack growth up to the stage of macro-crack formulation. Considered are the loading histories that correspond to normal traffic loading for highways and railways, incidental or accident loadings such as those caused by typhoons and effective environmental loadings. The potential sites of damage are determined are discussed. The proposed criterion is applied to analyze the fatigue damage of the Tsing Ma Bridge with online strain history data acquired by the SHM system that is permanently installed in the bridge.     

Effect of Free‐Stream Turbulence on the Flow Structure near a Wedge and the Windward Side of an Airfoil

The flow structure behind wire grids is studied for flows with a low subsonic velocity, and the effect of grids on the boundarylayer flow structure is considered. It is shown that the meanvelocity inhomogeneity induced by the grid does not disappear until a distance of 925 calibers downstream of the grid is reached. Liquidcrystal thermography combined with hotwire measurements made it possible to find the source of steady largescale streamwise vortex structures in the boundary layer on a wedge and on an airfoil and to determine the parameters of these structures.     

轮胎钢丝帘线拉伸力学性能的实验研究

对两种结构类型的钢丝帘线在单向拉伸和循环加载下的力学性能进行了实验研究。结果表明：帘线的结构形式对拉伸力学性能（包括摩擦能量损耗）有显著影响。不考虑载荷很小的情况时，普通结构帘线可近似为弹脆性材料，高伸长结构帘线却可以产生较大的塑性变形；循环载荷下，普通结构帘线几乎没有摩擦能量损耗，而高伸长结构帘线不仅有明显的摩擦能量损耗，而且随着循环应力幅值的增加，摩擦能量损耗呈加速增加的趋势；在循环应力幅值较大时高伸长结构帘线还出现了类似于高温下循环硬化金属材料的循环蠕变现象。文章还讨论了高伸长结构帘线由于塑性变形而引起循环蠕变现象的机理。     

轴心受压H型截面钢柱火灾行为的试验研究

本文对4根H型截面钢柱进行了火灾行为的试验研究。全部火灾试验采用自行研制的火灾试验炉,试验结果表明炉子性能稳定,使用方便。试验采用足尺试验形式,柱长3300mm。钢柱轴心受压,其中两个限制轴向变形,另两个不限制轴向变形。柱两端采用单向刀口支座,允许钢柱绕强轴转动。钢柱试验中考虑荷载大小和是否限制轴向变形两个因素。通过试验,得出了钢柱在火灾下的侧向变形和轴向变形随温度变化情况。试验证明:钢柱受火时,轴向变形明显的分为膨胀阶段和压缩阶段。压缩阶段很短,一旦进入压缩阶段,钢柱很快破坏。钢柱受到的外加荷载越大,其极限温度越低。限制轴向变形的钢柱极限温度降低。试验研究为今后钢结构火灾行为研究提供了依据。